|
C5 Open Discussion General and technical C5 Corvette discussion - ownership, maintenance, repairs, modifications, tuning |
|
Share | Thread Tools | Search this Thread |
04-30-2010, 4:13pm | #1 | ||||||
Vette Barn Crew
Join Date: Feb 2010
Location: Virginia Beach
Posts: 942
Thanks: 74
Thanked 97 Times in 83 Posts
Gameroom Barn Bucks: $377
|
The culprit!!
Well as you know I have posted about my under the hood/front suspension noise. Well today at hobby shop, I took of and reinstalled the front and rear sway bars and regreased and torqued to spec.
Then I figured I would look up torque specs on the leaf springs. SO I walk up to the front lef spring passenger side rear bolt and well I seen a gap that I could fit a quarter in!!!! And I could un screw it with my fingers! So go to the driver side and the rear bolt was also loose enuff to take out with my fingers but no gap. So re tightened them and now NO NIOSE
__________________
Arctic White 97 C5 Coupe NOT STOCK |
||||||
04-30-2010, 5:05pm | #2 | ||||||
Charter Member
C6 Modulator Barn Stall Owner #27 Barn Raising I,II NCM Supporter '13,'14,'15 Bantayan Kids '13
Join Date: Oct 2009
Location: Lone Star State
Posts: 29,424
Thanks: 16,018
Thanked 7,063 Times in 4,385 Posts
Gameroom Barn Bucks: $100108568
|
:awesome: Sometime those quirks end up being something ya never suspect! Glad ya found it.
|
||||||
04-30-2010, 5:29pm | #3 | ||||||
Vette Barn Crew
Join Date: Feb 2010
Location: Virginia Beach
Posts: 942
Thanks: 74
Thanked 97 Times in 83 Posts
Gameroom Barn Bucks: $377
|
Me too, Even when I took off the sway bars I knew they were torqued properly. so i just re did them , regrease and then well, good thing I wanted to just tighten EVERYTHING! lol
THanks no more clanking! Awesome pic huh, camera phone FTW! And tomorrow is LS6 INTAKE INSTALL!!!
__________________
Arctic White 97 C5 Coupe NOT STOCK |
||||||
04-30-2010, 6:16pm | #4 | ||||||
A Real Barner
Join Date: Nov 2009
Location: here there and everywhere
Posts: 1,619
Thanks: 498
Thanked 266 Times in 181 Posts
Gameroom Barn Bucks: $7813
|
Now you can here the V8 Rumble!! Glad you found it.....
|
||||||
04-30-2010, 6:17pm | #5 | ||||||
Vette Barn Crew
Join Date: Feb 2010
Location: Virginia Beach
Posts: 942
Thanks: 74
Thanked 97 Times in 83 Posts
Gameroom Barn Bucks: $377
|
Thanks, I am just ready to see the difference in maybe throttle response from putting the ls6 intake on now.
__________________
Arctic White 97 C5 Coupe NOT STOCK |
||||||
04-30-2010, 9:13pm | #6 | ||||||
Charter Member
Barn Stall Owner #00
Join Date: Oct 2009
Location: Traverse City, MI
Posts: 4,953
Thanks: 462
Thanked 710 Times in 518 Posts
Gameroom Barn Bucks: $2041885
|
Congrats on fixing the problem! Glad ya caught it before the bolts fell out.
Good luck with the intake swap.
__________________
00 MY coupe Some minor tweaks here and there. |
||||||
04-30-2010, 9:15pm | #7 | ||||||
Vette Barn Crew
Join Date: Feb 2010
Location: Virginia Beach
Posts: 942
Thanks: 74
Thanked 97 Times in 83 Posts
Gameroom Barn Bucks: $377
|
Thanks it was just by chance I found them. But since I had it up in the air I was like shoot imma tighten EVERYTHING!!! lol
__________________
Arctic White 97 C5 Coupe NOT STOCK |
||||||
05-01-2010, 6:35am | #8 | ||||||
Charter Member - C5 Mod
Barn Stall Owner #41
Join Date: Oct 2009
Location: hagerstown, md
Posts: 5,780
Thanks: 1,206
Thanked 1,291 Times in 827 Posts
Gameroom Barn Bucks: $8192878
|
You probably won't see a great increase in throttle response, unless you're going to a ported TB. You will see a slight increase in torque, and a slightly deeper exhaust tone. Don't forget to make sure you plug the vacuum line at the rear of the intake back in when you do the install. If you don't, you'll be chasing an HVAC problem and won't know why. Also, while you're at it, change out the hard plastic vacuum line for a rubber one. It goes down to the canister under the battery. The line is inside the big wire loom. Just replace it and run the new rubber one down to the canister. Five minutes here and you'll save yourself a lot of headaches later when the hard plastic one breaks, and it will break. They all do eventually.
Glad you got the CLUNK fixed. Them noises can drive you nuts man!
__________________
'98 Pewter coupe. A little of this and a little of that..... |
||||||
05-01-2010, 10:38am | #9 | |||||||
Vette Barn Crew
Join Date: Feb 2010
Location: Virginia Beach
Posts: 942
Thanks: 74
Thanked 97 Times in 83 Posts
Gameroom Barn Bucks: $377
|
Quote:
But I went to buy a new oil pressure sensor today since my old one is shot. oil pressure reads pegged! So I go to Autozone and their BWD one is like 47 bucks, I told them nah i aint paying that, so they had an ac delco at wards corner for 25. Hell I aint driving out there. So I left and went to pepboys and they had the same thing BWD for the same price.. I told them that autozone had it for 29.99. So they matched the price and I had to buy a fuel line disconnect kit which was 12bucks. then after military discount I paid like 27 bucks for both.
__________________
Arctic White 97 C5 Coupe NOT STOCK |
|||||||
05-01-2010, 12:57pm | #10 | ||||||
Vette Barn Regular
Join Date: Feb 2010
Location: VA Beach
Posts: 85
Thanks: 1
Thanked 8 Times in 5 Posts
Gameroom Barn Bucks: $980
|
Thats a deal, well played!
Mario |
||||||
|
|
Support the Barn: |
Download the Mobile App; |
Follow us on Facebook: |
||