Quote:
Originally Posted by SnikPlosskin
Good idea. I have tape under it and in all the cavities and will likely cut around each with a razor before pulling. I should probably remask for the 8 clear coats not that color is finished. Thanks! That kind of screw up is EXACTLY what I would do! I already have enough nits in the finish for an hour of sanding with 1500 grit before clear.  check out the subtle burst! |
It sure is pretty! Nits should be handled between coats so they don't show in the finished piece (like the grains of what looks like Bullseye). That will also help get the surface absolutely flat as the build finishes filling whatever grain the filler missed. ALWAYS use a block of some sort as you sand... fingers cut subtle trenches that will show in the final product.