Thread: [Advice]I need to have a small part fabricated
View Single Post
Old 06-12-2018, 1:46pm   #1
StaticCling
A Real Barner
Points: 39,993, Level: 100
Activity: 0.7%
 
StaticCling's Avatar
 
Join Date: Jun 2013
Location: I stick like glue
Posts: 9,155
Thanks: 2,660
Thanked 5,971 Times in 2,427 Posts
Gameroom Barn Bucks: $46509956
Default [Advice]I need to have a small part fabricated
This is reloading related...

I'm trying to mate my Harrell's Powder Measure to my Lee Classic Cast Turret Press. The Harrell's uses a clear acrylic drop tube held in place with a brass collet...

I have a Swivel Adapter that screws into the Expander Die with Riser...I think it would be possible to get another clear acrylic drop tube, or perhaps a hollow brass tube, and mill it down enough to fit inside the other side of the Swivel Adapter...Then it appears that I could thread the outside of the drop tube and inside of the swivel adapter to fit...In theory.

I just don't have a lathe or mill to do this. Any of you machinists and/or Tool people offer any ideas?
StaticCling is offline   Reply With Quote
The Following User Says Thank You to StaticCling For This Useful Post: