View Single Post
Old 06-12-2018, 7:16pm   #10
JRD77VET
Barn Stall Owner #327
NCM Supporter '16,'17,'19
Bantayan Kids '13,'14,'15,'17
GTMS 18
Points: 77,240, Level: 100
Activity: 99.6%
 
JRD77VET's Avatar
 
Join Date: Jan 2011
Location: Zionsville,PA
Posts: 38,247
Thanks: 18,228
Thanked 14,383 Times in 6,451 Posts
Gameroom Barn Bucks: $5969501
Default

Quote:
Originally Posted by DAB View Post
.....................



each side will get 104 holes, 52 in each column. 5 bookcases, 10 sides, 104 holes per side = 1040 holes.

how prescient, i just sent off my quarterly taxes today - form 1040.

so i'm 1/2 done, will do more tomorrow.

pic of holes:

did i mention that there is no AC in the shop? but it is fairly cool, and not bad with a small fan going.

I see your 1040 holes in wood and would like to present a stainless steel spin filter with the main body 3/16" thick that has 3/8" holes in it.

This 45" long item has 3105 holes in it.

Plus as an added bonus, the outside diameter must be turned to 7.500 +/- .005

At a feed rate of .008 per rev, that equates to literally a 1/4 MILLION impacts per cut. The carbide insert is only good for one pass. I had eight tools set up , one for each pass and also programmed .025 taper into each cut so it would cut straight ( due to insert wear )

My buddy Tony just sent me this picture today, he got to do this past run of parts since I no longer work at the tentless circus
Attached Thumbnails
spin filter.jpg  

JRD77VET is offline   Reply With Quote
The Following 2 Users Say Thank You to JRD77VET For This Useful Post: