1976.
I bought a replacement booster and MC from zip products, and I may be having
a problem with the push rods they included.
See 1st picture.
They included an adapter that goes inside the throat of the master cylinder (black, 1.5" long).
The push rod that goes in the booster is 2.375 long. When I put my measuring tool on the MC,
flip it over to measure the booster, the push rod is a little more than .125" too long.
Zip also included a long push rod (chrome, 3.375" long), but if I leave out the black adapter from
the booster, the rod is too short by 0.375". None of the rods/spacers are adjustable.
Has anyone used the black adapter and shorter rod without the brakes catching?
Master and booster made by MBM (china), booster looks like original booster
but push rod set-up is different.
I asked ZIP, they don't have any techs, and suggested asking CFC3.
The on-line only tech site for the manufacturer says tech tips for sellers only,
go ask ZIP.
Anyway, they do have a tech sheet that says use the adapter and the short
push rod, but I worry that the brakes will drag. I'll mount them Friday and see.
