View Single Post
Old 06-12-2018, 1:46pm   #1
chinaski
A Real Barner
Points: 28,735, Level: 100
Activity: 3.7%
 
chinaski's Avatar
 
Join Date: Jun 2013
Location: Earthquakeville
Posts: 8,268
Thanks: 2,325
Thanked 4,947 Times in 2,058 Posts
Gameroom Barn Bucks: $54124377
Default [Advice]I need to have a small part fabricated

This is reloading related...

I'm trying to mate my Harrell's Powder Measure to my Lee Classic Cast Turret Press. The Harrell's uses a clear acrylic drop tube held in place with a brass collet...

I have a Swivel Adapter that screws into the Expander Die with Riser...I think it would be possible to get another clear acrylic drop tube, or perhaps a hollow brass tube, and mill it down enough to fit inside the other side of the Swivel Adapter...Then it appears that I could thread the outside of the drop tube and inside of the swivel adapter to fit...In theory.

I just don't have a lathe or mill to do this. Any of you machinists and/or Tool people offer any ideas?
chinaski is offline   Reply With Quote
The Following User Says Thank You to chinaski For This Useful Post: