Took the car out for about 30 min tonight to get it good and hot and heat cycle the springs. Got the oil temp to 200, but it quickly dropped back in the 180s cruising so the oil cooler really works. One of my heim-joint endlinks (the RF) is really clanky, not sure if that means it's wearing out, but I knew they would click/clack some. I can grab the RF by hand and jiggle the center section back and forth and make it clank. The other 3 are movable, but much stiffer. Is this something I can address?
Problem I'm now facing is ride height... I have the car lowered to the max w/ the stock adjusters and it's still riding really high. Guess that's what happens when you take so much weight out of the car. Might have to dig into it and modify the spring adjusters to get it lower. Anyone run into this when gutting a C5?
Didn't notice anything negative from the Pfadt poly motor mounts. Some have complained about excessive vibration.
4x4 status w/ my junk shake-down street wheel/tire setup
Hood back on
