[ZipZap]

Originally Posted by lspencer534

I built a "rattle can" paint holder in the workshop, and I want to dress it up a bit. The rack is about 80" tall, 15" wide (holds 5 cans on each rack), and 5 1/2" deep; the racks holding the cans are slanted down at the rear about 15 degrees to help hold the cans in place.

On the sides of the rack (the 5 1/2" deep part) I want to add some 3/8" wide cove moulding. There will be two of these moildings, each about 37" high and 2 1/2" wide, stacked on top of one another. The cove moulding will be like "boxes", each about 37" high and 2 1/2" wide.

Question: Can you keep the paint off your face by huffing through a hankie?

Fixt.