07-10-2019, 8:37pm
|
#11
|
Sparkles Flambeaux Barn Stall Owner #4 Barn Raising I,II NCM Supporter '13,'14,'15,'16,'17,'21 Bantayan Kids '13,'14,'15,'17
Points: 172,101, Level: 100 |
Join Date: Jan 2011
Location: Santa Fe, NM
Posts: 61,464
Thanks: 11,772
Thanked 33,022 Times in 14,162 Posts
Gameroom Barn Bucks: $17500122
|
Quote:
Originally Posted by JRD77VET
What brake controller do you have? ( make and model)
|
Quote:
Originally Posted by GRN ENVY
What kind of trailer harness do you have at the back. You should have a 4/5 pin and a 7 pin. Your 7 pin will have you standard, running, brake, L and R signals, and brake inputs. If there is an 8th pin it's for reverse. Most newer trucks have an option for factory brake controller. This could be why you have two wires with no connectors. You should be able follow those two empty wires to your 7 pin. You can wire in but it may not allow for your trailer to signal the brakes until an actual trailer is connected in the pin receiver in the bumper.
Hope this helps
|
it's the factory brake controller. 7 pin. but the manual, as noted above, says 2 wires are run to the fuse box, but not connected.
|
|
|