[Cobra4B]

Front and rear tow hooks and rear T1 swaybar installed. The tow hooks are a hinged/folding design from Phoenix Performance. To install the rear you have to remove the bumper to replace the OEM muffler hanger bracket/bolt setup because the bolts are too short once the towhook is inserted between the hanger and rear frame bar. I fabbed up one to mimic the OEM piece so I could remove the muffler in the future if needed w/o having to take the bumper off again. If you just stuck longer bolts through theyd just spin if you ever needed to unnbolt the muffler hanger. The front bumper was allready off so it was a non-issue. Also, used some washers to lower the drivers side muffler hanger so I can allign the exhaust tips eventually.

Rear





Rear Bar



Front