View Single Post
Old 10-21-2009, 4:38pm   #9
Y2Kvert4me
Administrator
Barn Stall Owner #7
Barn Raising I,II,IV

NCM Supporter '13,'14
Points: 34,926, Level: 100
Activity: 0%
 
Y2Kvert4me's Avatar
 
Join Date: Oct 2009
Location: Pewaukee,WI
Posts: 8,215
Thanks: 1,044
Thanked 5,024 Times in 2,237 Posts
Gameroom Barn Bucks: $30682687
Default

Quote:
Originally Posted by willyfastz View Post
Advance Auto has one, BUT it's really cheap. I tried one and it one worked one time, after that the threads where screwed up.


Since I had mine out, and on the bench, I took a hammer and smashed the plastic pulley off it's hub. Didn't take long to make it 2 pieces.

From there, any appropriately-sized 2 or 3 jaw puller will remove the hub from the PS shaft.




I used the Advance tool to draw the new (aluminum) pulley on the PS pump shaft, but still had to heat the pulley to get it to go, as I would have broken the tool otherwise. (Synister PS pulley - it was a VERY tight fit).




Y2Kvert4me is offline   Reply With Quote