View Single Post
Old 04-29-2019, 07:11am   #91
SnikPlosskin
Barn Stall Owner #93
Points: 37,885, Level: 100
Activity: 15.1%
 
SnikPlosskin's Avatar
 
Join Date: May 2011
Location: Uranus, Tx
Posts: 6,865
Thanks: 764
Thanked 5,152 Times in 1,646 Posts
Gameroom Barn Bucks: $24713256
Default

Small update. I was looking inside the secondary hull to figure out how to run the rest of the wires than come from inside the saucer and down through the neck where they attach to the various systems.

Looking inside, there was a path but it had several corners and not much room. There are a shit load of wires that need to come through there (the ones you see all are for systems inside the hull. They each need hooked up to the circuit board controller in the saucer.) plus, wires for switches and power.

So I carved out some plastic from a reinforcement bar and pushed a conduit in there with the help from a heat gun.
Attached Thumbnails
61318E2D-1B9C-4F94-9922-13F42923DBE5.jpeg  

756182C8-2C36-46E8-BC67-8941A8A666A4.jpg  

SnikPlosskin is offline   Reply With Quote
The Following User Says Thank You to SnikPlosskin For This Useful Post: