View Single Post
Old 04-29-2019, 7:11am   #91
Barn Stall Owner #93
Points: 42,779, Level: 100
Activity: 4.9%
SnikPlosskin's Avatar
Join Date: May 2011
Location: Uranus, Tx
Posts: 7,684
Thanks: 944
Thanked 6,162 Times in 1,983 Posts
Gameroom Barn Bucks: $24716761

Small update. I was looking inside the secondary hull to figure out how to run the rest of the wires than come from inside the saucer and down through the neck where they attach to the various systems.

Looking inside, there was a path but it had several corners and not much room. There are a shit load of wires that need to come through there (the ones you see all are for systems inside the hull. They each need hooked up to the circuit board controller in the saucer.) plus, wires for switches and power.

So I carved out some plastic from a reinforcement bar and pushed a conduit in there with the help from a heat gun.
Attached Thumbnails


SnikPlosskin is offline   Reply With Quote
The Following User Says Thank You to SnikPlosskin For This Useful Post: