View Single Post
Old 06-12-2018, 1:59pm   #3
ToolMaker
Barn Stall Owner #97
Points: 12,292, Level: 76
Activity: 2.5%
 
ToolMaker's Avatar
 
Join Date: Feb 2013
Location: Tamworth, NH Wht. Mtn's
Posts: 8,193
Thanks: 7,055
Thanked 1,021 Times in 555 Posts
Gameroom Barn Bucks: $56470018
Default

Quote:
Originally Posted by chinaski View Post
This is reloading related...

I'm trying to mate my Harrell's Powder Measure to my Lee Classic Cast Turret Press. The Harrell's uses a clear acrylic drop tube held in place with a brass collet...

I have a Swivel Adapter that screws into the Expander Die with Riser...I think it would be possible to get another clear acrylic drop tube, or perhaps a hollow brass tube, and mill it down enough to fit inside the other side of the Swivel Adapter...Then it appears that I could thread the outside of the drop tube and inside of the swivel adapter to fit...In theory.

I just don't have a lathe or mill to do this. Any of you machinists and/or Tool people offer any ideas?
I would if I still had access to machines. Someone may chime in.
ToolMaker is offline   Reply With Quote