NCC-1701A Enterprise Refit
Well, due to an unfortunate Klingon misplaced soccer ball, the three foot long, fully lit Enterprise model I built more than ten years ago is roached. The upper hull saucer broke off and the wiring was just too short to fix. A couple weeks ago after I cut the wires to separate the disk, I could see that there was no way to repair it.
Oh well, 100+ hours down the drain.
So, I’m starting this build thread of a new 1/350 scale model. This time with far more sophisticated electronics and a new base that is waaaay more stable than the pile of crap on the original model.
There is a lot of modifying needed to make this work and I’ve started removing plastic that gets in the way of the lighting and modifying other areas to improve fit.
One of the first steps is light blocking with several coats of flat black, then a coat of flat white primer to make the insides reflect the light.
Some pics.
|