|
Barn Stall Owner #1776
NCM Supporter '11,'12,'13,'14,'15,'16,'17,'19,'20,'21
Bantayan Kids '13,'17
Points: 88,143, Level: 100 |
Join Date: Apr 2011
Posts: 15,359
Thanks: 5,730
Thanked 15,024 Times in 4,314 Posts
Gameroom Barn Bucks: $2002001941
|
Removed one off a C6 a few years ago, was half way up the hood and fenders as well. I'm experienced with using a heat gun, made pretty easy work of it.
However, if you are NOT experienced with a heat gun, don't even think about it.
You can use a good large hair dryer, start in a corner and start peeling. You may want it to sit out in the sun a bit first.
Don't expect it to rip right off like pulling cellophane off a left over dish, this is slow, tedious work, be patient, take your time, it will come off.
I can tell you though, if that was put over any re-painted surface other than factory, you could have some paint peeling issues. Work slow. Good luck.
__________________
JCS USA USN USMC USCG USAF USSF USAR USNR USMCR USCGR USAFR ARNG ANG USPHS NOAA USMM AUS CSA Police/Fire/EMS/EMT
 Thank You For Your Service
|