[Cobra4B]

Hardbar upper control arm studs and camber kit installed up front



Front suspension back together. New Z06 front monoleaf (the one I took off had started to split), fresh wheel hubs w/ ARP studs, new 2004 Z06 shocks, ECS spindle ducts, etc.




DRM brake cooling ducts in place. These attach to a modified OEM duct which, in stock form, really only blows air on the tire. Eventually a duct will run from this to the ECS spindle duct, but I have to wait until the steering rack is back in to cut the hose to proper length.



Removed the fender close-out panels. This allows better airflow through the engine bay.



Modified the OEM fan shroud to allow more air flow through the radiator and oil cooler.



Decided to wrap the rest of my h-pipe and used some spare heat shielding I had to make some shields for the top of the cats.



My Pfadt motor mounts and fixed ATI Super Damper should come in early this week so I can finish her up.

-Brian