I am not greatly knowlegdeable about the internals of our motors.
Today at the drag strip after about 5 passes the car sounds awful so I cut it off and waited a few minutes and cut it back on to hear this horrible noise. I had no choice to drive back since it was an hour away from home. My car is a 97 Targa, H/C stock block 75k around 424rwhp. Now at idle and while driving after this noise was heard here are the readings of my gauges
Oil Pressure-- between 19 and 23 psi while cruising the interstate/ normal is 38ish
Oil Temp-- hovered between 240 and 246 at 65 mph
Water-- normal 205 ish.
There are no codes and no leaks of any kind. I just walked in the door so I haven't had time to take off my Valve covers to see if its a bent rod or broken lifter. I will dig into it as much as I can with my abilities before I take it somewhere.
I am just looking for some opinions of where to start?
Heads?
Go straight for the block?
From what I have researched everyone says pull the oil filter and if there is metal shavings I have spun a Bearing.
Thanks for your time
Joshua