Oil pan gasket replacement
I had an oil leak from the right rear corner of the oil pan.
The oil pressure switch is dry, looking thru the access hole in the bell housing I can see just under the rear main and it is dry as well. it looked like it was coming from the upside down T area of where the rear main plate meets the block. I replaced both upper and lower oil pan gaskets and I now have a leak from that same right rear corner, although now it looks like it might be closer to the actual rear corner I did put a bead of RTV in all 4 corners where the covers meet the block When running I get a slow drip like it is being forced out from pressure. I put on a new PCV assembly from GM to eliminate any crankcase pressure. Is there anything that I should have done other than clean and apply RTV? Or is there a know issue with the rear main plate gasket? Easier to redo the O.P. gasket then pull the trans/torque tube assembly And thoughts? |
All times are GMT -5. The time now is 12:41pm. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by
Advanced User Tagging (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
Copyright © 2009 - 2024 The Vette Barn