Trouble with Flush Tail Light Install
I just received my Flush mount kit from Zip and I am have nothing but trouble trying to install the lights. The foam rubber that goes on the bottom half of the tail light openings forces the spacer blocks and screws to pinch inward. To make matters worse, I have the blackout kit from Vetteworks, which is the black plactic pieces. If I get one screw started, the other screw is on such an angle and there is no room to see if it is lining up with the hole.
Is there a secret to the installation, or is this just another mod that is p### poor engineered and collects the well known Corvette tax. |
I would call Zip @ 1-800-962-9632. Ask for Justin Abbott or J.T.Stafford. They can help you.
Gene :drivingskid: |
It took me a lot of cussing and several beers,take a break and come back to it,if I remember right the two outer lights were the pits.
|
i took my tinted covers off and tinted the lights themselves. then installed the flush kit. it was a PITA getting the screws in with that fat weatherstripping. i cant imagine it fitting with the tinted covers on it too :willy:
|
Sorry the hear that you having trouble,, That is why I am leaving mine stock, except for a water seal.:hi:
|
All times are GMT -5. The time now is 7:03pm. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by
Advanced User Tagging (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
Copyright © 2009 - 2024 The Vette Barn