What ya workin on?
 

I am poor and not really doing anything to my car at the moment. Spent all my $$ on new heads a few months ago. I'd love to hear what someone else is doing to their car though. What ya got, stroker build, new cam, forged internals? Anything?

if i had the money i'd swap my AFR 205's with something that would fit nicely with a polished maggie... but thats not gonna happen so im happy with my H/C 460RWHP, jump in an drive cross country all day long convertible Z06... ok maybe a Fast 90 setup one of these days...

Fixin this on the 97'.................upgraded 3.73 rear
http://forums.corvetteforum.com/phot...4/DSC_0054.jpg

http://forums.corvetteforum.com/phot.../parts_119.JPG

http://forums.corvetteforum.com/phot...ebuild_080.JPG

Ouch!

I am installing a meth kit, hope to post some pics of the install on here in a few days.

nothing here unfortunately... Im out cash...lol But hopefully this time next year i can start saving for my forge build...:cheers:

Not much left on the car to do. I do have a set of Jhonathan's 1.5 tint Halo's coming Friday. I didn't want to spend the $$$ only to have LE tell me to take them off so I;ve been running tinted covers. I've been stopped once and warned twice. The 1.5 tint should just take the hard red out of the lights and the LED setup should be bright enough to satisfy LE. I'd love to find a single disk clutch to replace the rattling RAM Dual I have in there now. It works great but I just hate the rattle.

Happy Thanksgiving Barn Folk!!!

yea you should be good to go..i got the stg 2 but Im pretty confident the LED Halos will be bright enough to deter any LEO form pullinig me..

saving up for the spring supercharger is the plans

Projects
 

C4-Open Road Race car:
Total engine rebuild, lost oil pressure at 204mph. Wasted all bearing rods, pistons.

C5 01 ZO6 Twin turbo:
Partial engine rebuild. Had bad head gasket so was getting anti-freeze in cylinder 7 due to over heating. Hone cylinder, possible new piston, install new Radiator and fans

C6 o7 coupe:
finish tune(it is almost got all the little bugs out)

I'm about 90% of the way through doing a partial wire-tuck, coil relocate, PCV/Catch Can mods and new inlet piping. Here's a few in progress pics;
http://members.cox.net/joe.creecy/mockup01.JPG
http://members.cox.net/joe.creecy/mockup02.JPG
http://members.cox.net/joe.creecy/mockup03.JPG

Looking very Nice.

Sweet, but I think your valve covers are missing a couple of bolts. :lol: