Next Step....
 

Well I sold my D1SC kit today. Just waiting for the E-Check to clear before I send it off. And well I have decided with the cash I will have from it I plan on going with-

Cam kit from VA Speed.
Marios- 243 heads Ported.
Underdrive pulley
Ed tuned.
So shooting for over 400rwhp thats my goal. That will prolly be all for now until I want more then I guess 100 shot :D:beer:

Sounds like a plan!

So far that is the plan lol:cheers:

Yeah, and I'm done modding...:rofl:

After this weekend anyways. I'm replacing the BA component speakers in the door with some JL C5 650's and replacing the blown JL 10w3 sub. I guess I'll install the shift light at the same time. But after that, no more mods...:lolsmile:

Sounds like fun! :drivingskid:

Those are mods but stylistic accessories. haha. And well not sure what else you would need with a motor like that.

Someone must be doing some farming in here, cause it sure smells like BS! :dance:
:cheers:

You can make way more than that w/ ported 243s. My Z06 makes 436 rwhp w/ a G5-X2 cam and stock 243 heads.

Well Brian, I am not a Zo6 so I am keeping my Expectations low so if it goes higher I will be amazed. But good point nonetheless

With VA speeds cam spec and Shawn's port on those 243's i think you will be happily surprised.

455 rwhp 410 rwtq My guess!!!!

You have the lighter flywheel to right?

My car goes in Monday for the Trick flows let me know if you want them to port those heads?


About 100 rwhp for $4 grand not bad!!

Mario

Met up with Mario at VA speed this morning. Talked to Shawn and Ed. Soon as my E-Check clears, $3700 bucks For H/C swap and all. ALSO I didnt even know this. but My car already has an LS6 Intake. Shows how much I know about car parts.. So if anyone need an LS6 intake let me know $280

Once the heads and cam are changed, it doesn't much matter if the engine started life as a LS6 or LS1, as the heads and cam are the primary differences between the C5 and Z06 engines.
Only subtle differences will remain. (MAF and fuel system come to mind). So in theory, applying the same mods to either, should produce about the same dyno results.

I would not be surprised to see you top Brian's hp #, but if I predict correctly, it will probably be done via better heads and a more docile cam than Brians. ;)

:cheers:

Not sure of the specs of the cam kit but it would be the same as the one that Mario has on his car. And 243 heads ported and tuned. So I would guess 430 ish. If i get that I will super stoked.
Next week I should set up my date for install.
And you are right. Fuel system will be stock and will suffice for now. Until I get tired of this HP Then I guess a100shot lol

That should make mine a ZOcoupe. Minus the rear end and tranny. :rofl:

but before any more power I would look into upgrading said rear and tranny, those are going to be the weakest links.

Tom hit on it.... once you put 243s on the car and change the cam and put a LS6 intake on the car it doesn't matter what the shortblock is.

Put a BIG GIANT nasty cam in it so you'll end up hating the car.

Sorry, I forgot this wasn't CF...:D

Bigger is always better, but not always for a camhttp://i29.photobucket.com/albums/c2...s/55425421.gif

Or a wife......:leaving:

HAHAHAHA:o_o::lol: