Cup holder
Maybe an update to the floormat installation guide is needed?
Corvette Forum - View Single Post - Cup Holder Install? :dance: |
|
Bet most guys don't need installation instructions for that!
|
I sort of like this cup holder....:seasix:...WW
http://i217.photobucket.com/albums/c...psd13cc91c.jpg |
5 Attachment(s)
When I first got my '95 Corvette, I purchased a cup holder from one of the aftermarket suppliers. My wife was never completely satisfied with it because it stuck out too far into her leg room. After seeing how the aftermarket model was mounted, I decided to make a new one from some 22 gauge sheet metal, sticky felt material, plastic door edge guards, and two folding cup holders that I have used on my 1990 K-Blazer. You can see the results in the following photos and how it mounts without any drilling of holes in the Corvette. I mounted the cup holders to the holder with pop-rivets. I also used a metal bending brake to bend over about 1" all along the long edge for added strength to that smaller supporting part of the metal that goes all the way to the floor.
Attachment 34405 Aftermarket cup holder Attachment 34406 my DIY cup holder with cup holders folded up Attachment 34407 DIY cupholder with cub holder unfolded ready for use Attachment 34409 backside of sheet metal showing bend over re-inforcement Attachment 34408 Back side of DIY cup holder You can also see this on page 108 of the February 2019 issue of Vette Vues Magazine. |
All times are GMT -5. The time now is 12:22am. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by
Advanced User Tagging (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
Copyright © 2009 - 2024 The Vette Barn