62 4-speed shifter question
 

Hoping someone can help me with this.. Pulled the clutch on my 62 327 4-speed car. On the original shifter there is a 1/4" diameter pin that holds the stick shift to the cross shaft.. That pin was half way out when I removed the shifter. It pushed back to the center easily.. What is supposed to hold it in place?
I added a picture to this post. I hope you can see it. You can see the end of the pin at the lower right . Thanks
Alan

Sorry, but the first thing I change out is the shifter to a Hurst so I never have to worry about it again. And that was a long time ago on my 62.
Look in your shop manual or ask on the Corvette Forum C1+2 forum. They're quick with a response and good guys as well.
This link should work....:thumbs:
C1 & C2 Corvettes, 1953 - 1967 - Corvette Forum