ooh, ahh - this turns me on

[SnikPlosskin]

:hurray:

Just look at it.


Did it move for you?

[Datawiz]

Where's the 3rd pedal? :leaving:

[CertInsaneC5]

:Jeff '79:

[Kevin_73]

Where's the 3rd pedal? :leaving:

The gas pedal is floor mounted. :slap:

[Datawiz]

The gas pedal is floor mounted. :slap:

:lol:

[ApexOversteer]

Ooooo check it out... the clutch pedal is aligned with the brake pedal! :D

[Kerrmudgeon]

Very cool, nothing like a little team work.:thumbs:

You may want to trim those screws off on your new fangled racing pedals there Pete! :rofl:
They might hit your carpet. :bilmem:

[SnikPlosskin]

Very cool, nothing like a little team work.:thumbs:

You may want to trim those screws off on your new fangled racing pedals there Pete! :rofl:
They might hit your carpet. :bilmem:

I knew someone would see that!

Ricer pedals. I put them on there because the stock rubber pads would not stay on and the damn pedals where slippery. Those work quite nicely.

[SnikPlosskin]

Ooooo check it out... the clutch pedal is aligned with the brake pedal! :D

Crazy I know.

[Kerrmudgeon]

I knew someone would see that!

Ricer pedals. I put them on there because the stock rubber pads would not stay on and the damn pedals where slippery. Those work quite nicely.

I gave up putting the new rubber on the clutch pedal a few years ago. I'm going to do it again this year with contact cement and cross wired across the back....should work. As long as I stop side stepping the clutch....hahaha...:D

[Chris Fowler]

Does that make the clutch easier to push? :willy:

[Black94lt1]

I like it, looks damn near original :seasix:

[JRD77VET]

That turned out great :yesnod:

[MrPeabody]

I like it, looks damn near original :seasix:

I bet it would fool an NCRS judge.:yesnod::seasix:

[JRD77VET]

I bet it would fool an NCRS judge.:yesnod::seasix:

Not to distract from the excellent work but the original was spot welded on and Pete's new piece was mig welded on.

[MrPeabody]

Not to distract from the excellent work but the original was spot welded on and Pete's new piece was mig welded on.

I doubt they would catch that given the location of the part. But I have no experience with NCRS judges first hand. At the worst, they would think it was repaired.

[simpleman68]

Looks great Pete. And yeah... It gave me a bit of wood.
Scott

[SnikPlosskin]

Does that make the clutch easier to push? :willy:

Remember when you drove it? It was like shifting a tractor because the pedal rode so high? That little doohicky we made limits the travel of the pedal when you take your foot off.

Big time improvement. :hurray:

[SnikPlosskin]

Not to distract from the excellent work but the original was spot welded on and Pete's new piece was mig welded on.

Hey, this guy is good. Very good.

[Chris Fowler]

Remember when you drove it? It was like shifting a tractor because the pedal rode so high? That little doohicky we made limits the travel of the pedal when you take your foot off.

Big time improvement. :hurray:

Yeah...when you have to avoid the steering wheel with your knee when shifting something is not right. :rofl:

(and I have short legs...)

[OldSarge]

Makes me wet, good job.