PDA

View Full Version : LED Lights/Sequential turn signal/Harness


MYSCZ06
11-01-2009, 02:40am
My buddies will be installing my lights tomorrow (sunday). I purchase the all exterior LED lights and tails with Halo mod from JWMotoring. He sent the harness along with all the lights. I also purchased the sequential turn signal harness form SCParts. My question is will there be any issues pluggin all these in and in what order do they go? I wont physically be there when the stuff is installed so I have no idea what they are looking at. I shot Jwmotoring an email but figured I would ask here see if anyone has any knowledge. Will it go car harness = sequetial harness= JW supplied harness= to taillights or another order? Thanks for any input. Thought I would throw this out see if anyone new until i got a reply from JW so I can pass the info to them make the install a little easier...

Munch
11-01-2009, 07:37am
I'm not sure what the JW harness is as the tails just plug directly in to the factory harness and the sequential harnesses that I have seen go between the tails and the factory harness. All the other LEDs just plug in like a normal bulb.

Maybe the JW harness is a hyperflash preventive which would go in the dash up and behind the knee bolster.

MYSCZ06
11-01-2009, 07:58am
Yup thats where his harness will go..I got some info from tstar on CF...felt like a dumbass when I read his reply...pretty much same as yours the hyperflash harness goes under the dash the sequential harness plugs into the rear tail leads coming from car then into the lights themselves...lol