aloehr
06-19-2014, 10:37am
Hoping someone can help me with this.. Pulled the clutch on my 62 327 4-speed car. On the original shifter there is a 1/4" diameter pin that holds the stick shift to the cross shaft.. That pin was half way out when I removed the shifter. It pushed back to the center easily.. What is supposed to hold it in place?
I added a picture to this post. I hope you can see it. You can see the end of the pin at the lower right . Thanks
Alan
I added a picture to this post. I hope you can see it. You can see the end of the pin at the lower right . Thanks
Alan